Do you know how to clean your furnace correctly in Edmonton?

Published On October 5, 2017 | By Clare Louise | Home improvement

Do you know how to clean your furnace correctly?

A lot of people rely on a furnace to keep them warm during the cold winter months. Due to the amount of air that passes through the furnace and its filters, dirt and other particulate matter can accumulate and reduce the efficiency of the furnace. Therefore, it is important that your furnace gets cleaned from time to time. Calling a professional to do your duct cleaning in Edmonton can be expensive and this is why it might be a good idea for you to do it yourself.

But, before you start, safety first

Before you get started cleaning your furnace, you should take note of a few things. First, since most filters have components that run on electricity, all of these have to be turned off before you start. Second, most furnaces are metallic and have sharp edges. It is, therefore, a good idea that you get some gloves to protect your hands. Because there might be a lot of dust flying around, especially when you get to the filter, it is also a good idea that you get a face mask.

One last thing before we begin – it is important to take care not to bump the gas metering and the over-temperature cutout. These are very important to keep the furnace working as it ought to. If you are worried about this, maybe it would be wise to get commercial furnace cleaning services from a professional. Now, to the cleaning!

Start with the outside

Since the furnace can get quite hot, it is advisable that you give it a few hours to cool after switching it off. Removing dirt on the exterior can be done easily using a soft cloth or feather duster. Just ensure none of the material used during the cleaning gets stuck on the furnace. It is also a good idea to clean the ductwork at this stage before getting to the inside.

Now, what’s on the inside of the interior of the furnace depends on the model you have. There are lots of guides on the Internet on how to do that. Some models do come with instruction manuals and that might be a good place to start.

The main parts

The main parts of the furnace are the blower, filters and control systems. Most of these are located at the bottom of the inside of the furnace. Start at the bottom, again using the feather duster you used on the outside. A blower can also be used if you discover loose dirt. This dirt gets circulated whenever

the blower is on and gets into the filters and ducts, which is why it is very important that you clean this part first when doing duct cleaning in Edmonton.

Most filters are made out of dense woven material with small pores or porous paper. If there is dirt on the filters, the effectiveness of the whole system is compromised. Cleaning the filter is best done using a vacuum cleaner. Remember not to use any liquids here because most filters are destroyed by water or detergents. If the filter is too dirty to clean or is too worn out in your assessment, you can always get a replacement from companies that offer commercial furnace cleaning services.

Like this Article? Share it!

About The Author

Comments are closed.